How to perform first-aid repairs for damaged chassis systems of Petrol Car

It`s really a headache to have your car break down when you`re far away from the repair station. If you are prepared, you will be safe. After owning a car, you should pay attention to the maintenance of the car.

When it comes to the maintenance of Petrol Car, chassis maintenance is easily overlooked by drivers and friends, but in winter or wet weather, the importance of chassis maintenance is obvious. In order to maintain the chassis in winter, it must be thoroughly cleaned and rust-proofed. First, clean the chassis thoroughly. If there is too much mud on the chassis, it should be washed with detergent again to remove the oil stain, so that the original natural color of the chassis can be exposed so that anti-rust care can begin. In professional beauty salons, Petrol Car can be raised to a lifting frame for chassis cleaning, wiping, and then anti-rust care. What needs to be noted is that after cleaning, you must wait until the water on the chassis is completely dry before performing anti-rust care. During care, an even spray coating must be maintained to create a long-lasting, uniform rust-proof coating. After all the work is completed, let it dry naturally for 5-10 minutes to complete the anti-rust treatment of the chassis.
After professional chassis care, that doesn't mean it's foolproof. There is a misconception that people often go into cleaning Petrol Car in order to drive a Geely Car themselves, and often add some detergent. At this time, please be careful not to use alkaline cleaners? Laundry powder, etc? Clean the body and chassis, otherwise it will affect the anti-rust effect and shorten the anti-rust time.
It is recommended that you go to a professional beauty salon for basic care. There is an easy way to test the quality: after high-pressure water spray washing, the anti-rust care chassis has almost no water droplets. This effect means that real care provides excellent protection against rust.
When a Geely Car is in the wild or far away from the repair location, if the chassis parts are damaged, you can use the following first aid methods to drive to a place with different fault repair conditions.
If the brake wheel cylinder leaks brake fluid or the wheel cylinder pipe is broken, you can use iron sheet and copper sheet to make a small pad at the joint of the wheel cylinder pipe, block the pipe, and then tighten the screws, or clamp the fracture flat and curl it to block it. , making the wheel unable to start. But this may cause unilateral braking, so pay attention to safety when driving.
The brake master cylinder lacks brake fluid, which can be replaced with alcohol or liquor. In special cases, water can be used instead. Brake the cup to rise, and soak the rising cup in hot water for 10-20 minutes to remove the oily components on the cup and restore the cup to its original size.
Clutch friction plate corrosion and slipping can be used for less severely ablated friction plates. If it is severely ablated, you can use a layer of cotton or canvas, steel wire or iron wire to pass through the holes in the steel plate to fix it. When driving a vehicle, start smoothly and shift gears quickly.
The tie rod ball segment is damaged. On the bumper or other places that do not affect driving, remove the screws similar to the total length of the ball segment and replace the damaged ball segment. After installing the steering arm and nuts, use a hammer to rivet the exposed parts of the screws. If the differential gear of a three-axle Geely Car is damaged, such as either the center axle shaft or the rear axle differential, you can remove the drive shaft and half shaft and continue driving. If the front differential is damaged, you can remove the wheel connecting plate and continue driving.